|
|
1. Start with a clean layout.
|
2. Remove layout felt from front of table.
|
3. Use pattern to mark padding cutout.
|
4. Padding cutout as shown:
|
5. Remove Padding as shown:
|
6. Use pattern to mark centers of drill holes.
|
7. Drill holes as shown:
|
8. Drill 1-1/2" (38mm) holes at marks.
|
9. Install mount using outer holes (Spacers may be used under mount, 1/8" (3mm) spacers with 3/8" (9mm) pad, 1/4" (6mm) spacers with 1/2" (12mm) pad. No spacers needed for 1/4" (6mm) pad).
|
10. Remove Paper backing from cover pad and place over mount.
|
11. Reattach layout felt to table. Cut a slot in the layout, over the mount.
|
12. Insert MAXTime into table and secure. Tighten until MAXTime is flush with the top of the layout.
|
