MAXTime® Installation

Installation Instructions
Step By Step Installation Instruction for the MAXTime® Unit

1. Start with a clean layout.

2. Remove layout felt from front of table.

3. Use pattern to mark padding cutout.

4. Padding cutout as shown:

5. Remove padding as shown:

6. Use pattern to mark centers of drill holes.

7. Drill holes as shown:

8. Drill 1-1/2" (38mm) holes at marks

9. Install mount using outer holes (Spacers may be used under mount, 1/8" (3mm) spacers with 3/8" (9mm) pad, 1/4" (6mm) spacers with 1/2" (12mm) pad. No spacers needed for 1/4" (6mm) pad).

10. Remove paper backing from cover pad and place over mount.

11. Reattach layout felt to table. Cut a slot in the layout, over the mount.

12. Insert MAXTime® into table and secure